Figure 3 PL spectra of pristine and treated Si NWA samples PL sp

Figure 3 PL spectra of pristine and treated Si NWA samples. PL spectra of treated Si NWA samples prepared with H2O2 concentrations of (a)

0.5, (b) 2, and (c) 5 M at room temperature. The symbol ‘*’ denotes the multiplying factor relative to their original PL. (d) Temperature-dependent PL spectrum of oxidized Si NWAs obtained at 5 M H2O2 concentration. To our surprise, after oxidization, the PL peaks have a red shift for all the samples. The shift increases with the porosity of NWAs, and a maximum shift of 50 nm from 750 to 800 nm was observed for the sample prepared at 5 M H2O2 concentration. This phenomenon cannot be explained by the quantum confinement (QC) effect. According to QC theory, the bandgap should increase with the size decrease of the nanostructure by oxidization and lead to a blue shift. Moreover, their temperature-dependent PL spectrum also indicates that the light emission did not originate from the QC effect. As shown in Figure AZD5582 supplier ERK inhibitor 3d, the intensity of PL increases with decreasing temperature, while the peak position remains stable. Apparently, the emission mechanism is also contradictive with the well-known Varshni formula in the QC that it will induce a blueshift with decreasing temperature. At the same time, the emission linewidth decreases with increasing temperature in porous Si NW arrays. This abnormal phenomenon has been explained by a multilevel

model for light emission as discussed before [18]. Simultaneously, HF treatment on the Si NWAs always arouses the great decrease of intensity. We know that HF treatment removes the Si-O layer and introduces the Si-H bonds on the mafosfamide surface, which will impede the formation of new Si-O bonds, so light emission and its enhancement should be related to the Si-O-bonded nanostructure. The localized state related to Si-O bonds and self-trapped excitations in the nanoporous

structures are the main origins of the light emission. With the increase of the porosity of Si NWAs at high H2O2 concentration, it offers more light-emitting centers and the PL intensity is greatly enhanced. From Figure 3a,b,c, it is found that the small shoulder in the short wavelength corresponding to the p2 peak disappears, and it agrees well with the discussion in [19]. Conclusion Si NWAs on Si substrates with different morphology were prepared by two-step metal-assisted chemical etching. With the increase of porosity, the light emission intensity increases. Surface treatment affects the intensity significantly, and oxidization substantially strengthens the intensity. The origin of the strong emission of Si NWAs is concluded to be from the localized state related to Si-O bonds and self-trapped excitations in the nanoporous structures. Acknowledgements This work was supported in part by the Major State Basic Research Development Program of China (grant nos. 2013CB632103 and 2011CBA00608), the National High-Technology Research and Development Program of China (grant nos.

Comments are closed.